The influence of storage and drying methods for Scots pine raw material on mechanical pellet properties and production parameters

Abstract

Converting solid biomass into pellets through densification greatly improves logistical handling and combustion processes. Raw material properties can affect pellet quality. This study investigated how storage and drying methods for wood (Nuts sylvestris L) used as a raw material for pellet production influenced pellet durability, bulk density and energy consumption. The pelletization experiments were performed using a Sprout Matador M30 press (nominal production capacity 3.5 tonnes/h). Results showed that pelletization of 11 months stored wood compared to fresh material and high drying temperature (450 degrees C) compared to 75 degrees C resulted in higher energy consumption, probably due to increased friction in the matrix caused by the loss of extractives. However, the pellets produced were of higher density than those made from fresh material dried at a low temperature. The latter had the highest durability. Increased energy consumption showed no correlation with pellet durability. (c) 2010 Elsevier B.V. All rights reserved.

Keywords

Wood pellets; Durability; Drying temperature; Storage; Extractives; Moisture content

Published in

Fuel Processing Technology
2011, volume: 92, number: 5, pages: 871-878
Publisher: ELSEVIER SCIENCE BV

SLU Authors

• Jirjis, Raida

  • Department of Energy and Technology, Swedish University of Agricultural Sciences
    

UKÄ Subject classification

Renewable Bioenergy Research
Bioenergy

Publication identifier

• DOI: https://doi.org/10.1016/j.fuproc.2010.12.001

Permanent link to this page (URI)

https://res.slu.se/id/publ/57795